CRX 225 Manual Del Operador página 14

(4) Repair or replacement of any warranted part under the warranty provisions of this article must be performed at no
charge to the owner at a warranty station.
(5) Notwithstanding the provisions of subsection (4) above, warranty services or repairs must be provided at distribution
centers that are franchised to service the subject engines or equipment.
(6) The owner must not be charged for diagnostic labor that leads to the determination that a warranted part is in fact
defective, provided that such diagnostic work is performed at a warranty station.
(7) Throughout the emissions control system's warranty period set out in subsection (b)(2), FNA must maintain a supply of
warranted parts sufficient to meet the expected demand for such parts and must obtain additional parts if that supply is
exhausted.
(8) Manufacturer-approved replacement parts that do not increase the exhaust or evaporative emissions of the engine or
evaporative emission system must be used in the performance of any warranty maintenance or repairs and must be
provided without charge to the owner. Such use will not reduce the warranty obligations of FNA.
(9) The use of add-on or modified parts may be grounds for disallowing a warranty claim made in accordance with this
Article. FNA will not be liable under this Article to warrant failures of warranted parts caused by the use of an add-on or
modified part.
(10) FNA shall provide any documents that describe FNA's warranty procedures or policies within five working days of
request by the Executive Officer.
(d) A list of all emissions warranty parts must be included with each new engine or equipment subject to this Article.
The emissions warranty parts list shall include all parts whose failure would increase exhaust or evaporative
emissions, and contains the following parts (if applicable):
(1) Fuel Metering System
● Carburetor and internal parts (and/or pressure regulator or fuel injection system).
● Air/fuel ratio feedback and control system.
● Cold start enrichment system.
(2) Air Induction System
● Controlled hot air intake system.
● Intake manifold.
● Air filter.
(3) Ignition System
● Spark Plugs.
● Magneto or electronic ignition system.
● Spark advance/retard system.
(4) Exhaust Gas Recirculation (EGR) System
● EGR valve body, and carburetor spacer if applicable.
● EGR rate feedback and control system.
(5) Air injection System
● Air pump or pulse valve.
● Valves affecting distribution of flow.
● Distribution manifold.
(6) Catalyst or Thermal Reactor System
● Catalytic converter.
● Thermal reactor.
● Exhaust manifold.
(7) Particulate Controls
● Traps, filters, precipitators, and any other device used to capture particulate emissions.
(8) Miscellaneous items Used in Above Systems
● Vacuum, temperature, and time sensitive valves and switches.
● Electronic controls.
● Hoses, belts, connectors, and assemblies.