Greencut GHT650C Guía De Mantenimiento página 14

MAINTENANCE
ELECTRICAL INFORMATION
Before using this appliance, check that the voltage of your mains supply is the same as that indicated on
the rating plate of the appliance. In the UK this is 230-240 volts.
GENERAL INSTRUCTIONS
WARNING: If the power cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons to avoid a hazard. The power cord (cord) is terminated with a UK approved
mains plug and fitted with a 13A fuse. If the fuse needs to be replaced, an ASTA or BSI BS1362 13A
approved fuse must be used. If you change the mains plug, remove the fuse and dispose of the old plug
safely and immediately after cutting it off from the power cord (cable). The wires of the power cable are
colored according to the code: Blue: NEUTRAL, Brown: LIVE.
As these colors may not correspond to the colored markings identifying the terminals of your plug, proceed
as follows: BLUE or BLACK colored wire should be connected to the terminal marked with the letter N.
BROWN or RED colored wire should be connected to the terminal marked with the letter L. (If the product
has a VDE plug, this section can be omitted). Always unplug the unit before performing any adjustment
or maintenance operations. If the power cord is damaged, it must be replaced by the manufacturer or its
service technician to avoid hazards. Disconnect immediately from the mains if the power cord is damaged.
Be careful not to expose this tool to rain.
Avoid using solvents when cleaning plastic parts. Most plastic parts are susceptible to damage from various
types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, carbon
dust, etc.
LUBRICATION
Blade: clean and lubricate after each use.
Drive mechanism: lubricate every 30 hours of use or once a year.
DECLARATION OF CONFORMITY
We, BESELF BRAND S.L., owner of the GREENCUT brand, with registered office at c/Blanquers, 7-8
43800 - Valls, SPAIN, declare that the treadmill MC-500, from serial number 2017 onwards, is in
conformity with the requirements of the applicable European Parliament and Council Directives:
Directive 2014/30/EU of the European Parliament and of the Council of 26 February 2014 on the
harmonization of the laws of the Member States relating to electromagnetic compatibility (recast).
The delivered product matches the specimen that was subjected to the EC type examination.
Valls, July 31, 2017,
Mireia Calvet, CEO (Authorized representative and responsible for the technical documentation).
14
EN - GHT650C