Start/Stop Motion; Changing Batteries; Changing Batteries Continued; End Of Work Shift - Rubbermaid 2173661 Guía De Operación

Speed Control
Knob
Brake Control
Paddle
Safety Key Slot
Brake Control Cable
5.5

START/STOP MOTION

Grab the handle, squeeze and hold the right-hand paddle to start
movement. Release the paddle(s) to stop. On brake equipped
systems, squeeze the left paddle to quickly stop motion.
NOTE: The Housekeeping cart does not have brakes. You may
squeeze either or both paddles to start motion. You must release
both paddles to stop motion.
5.6

CHANGING BATTERIES

While working, you may notice the machine is slowing down.
Check the battery as shown below. If it is low and there is
another charged battery, change batteries.
CHECK BATTERY CAPACITY
Press the battery capacity indicator (BCI) button. The lights will
illuminate according to the remaining battery capacity level. See
chart below:
1. BATTERY CAPACITY INDICATOR (BCI) BUTTON
2. LED CAPACITY INDICATOR
Lights Capacity
4 Green Lights The battery is above 80% capacity.
The battery is between 80% and
3 Green Lights
60% capacity.
The battery is between 60% and
2 Green Lights
40% capacity.
The battery is between 40% and
1 Green Light
25% capacity.
The battery is less than 25% capacity
Lights go out
and requires charging immediately.
Forward/Reverse
Switch
Motor Control
Paddle
Motor Control Cable
English
5.7

CHANGING BATTERIES CONTINUED

Change the batteries as follows:
1. Stop the machine.
2. Pull the safety key to turn off the controls.
3. Lift the battery cover.
4. Lift and hold up the left battery latch.
5. Pull out the left battery and lay it aside.
6. Lift and hold up the right battery latch.
7. Pull out the right battery and align and push it into the
left slot.
8. Put the discharged battery into the right slot.
9. Close the battery door.
10. Insert safety key and return to work.
NOTE: If you do not have a spare battery, the machine can still
be used manually without power. The empty battery should be
taken back to the charger to be fully charged for next use.
Battery Cover
Battery Latch
Working Battery
System Controller
5.8

END OF WORK SHIFT

At the end of the work shift:
1. Return your machine to its storage location.
2. Pull the safety key to shut down the controls.
3. Remove the batteries (1) and place them on a charger (2).
4. Make sure the charger is plugged in and the green light (3)
is flashing.
5
EN
Spare Battery