Publicidad
Idiomas disponibles
Idiomas disponibles
870 mm (34-1/4")
WARNING
•
One wall stud MUST be located and USED for at least one side of the diaper changing station.
•
The diaper changing station CANNOT be heavier than the anchors or walls they are attached to.
MUST be firmly secured in order to support the additional weight of a child. Contact an architect or
building contractor for further questions.
INSTALLATION
1.
Locate wood stud where left side of changing station will be mounted to the wall.
2.
Measure up 107 cm (42") from the floor and mark the wall. This locates the position for the top
left attachment hole.
NOTE: Mark on wall MUST be in center of wood stud.
3.
Align hole in top left corner of changing station with mark on wall and hold in place.
4.
Using a level and measuring tape, mark the remaining three (3) holes. After marking holes, set
changing station down on ground.
5.
Use a power drill and appropriate bit to drill four (4) holes in the wall. This may require 2 people.
A
Flat
washer
Finishing
washer
Wood
screw
Changing Station
Instruccions cambiador pañ a les.indd 8
Wood stud
500 mm (19-7/10")
B
Wood stud
Changing
station
516 mm (20-3/10")
C
Toggle
anchor
Flat
washer
Machine
screw
20/5/19 17:08
Publicidad
