Publicidad
Idiomas disponibles
Idiomas disponibles
User and installation manual
10
Persons with reduced physical and mental capacity, sensory handicap, or little experience and knowledge about how the
device is operated (e.g. children), should only operate the device while supervised or according to instructions given by the
persons in charge of their safety.
Make sure that children aren't playing with the sauna heater.
Installation of the control panel and the sensor
The control panel is splash proof classification IP X4 and may be mounted in the damp area outside the sauna room. The
control panel may not be installed inside the sauna room.
The sensor is installed in horizontal position at a distance of 40 mm from the roof on the centerline of the heater.
The installation and connection of the sauna heater, control panel or any other electrical appliances may be done only by a
licensed electrician in accordance with the national electrical regulations.
High temperature limit
If the temperature in the sauna should rise too high (for example due to a thermostat fault) the limit switch in the sensor will
turn off the power. When the fault has been repaired by an electrician the switch may be reset.
Before resetting the high limit switch, always make sure the fault is corrected!
OT 2 PLE
PROG
OK
2 1 9 3 4 5 8 7 6
1
1. On / Off button
2. Sauna light button
3. Pre-selection button
4. Operating time button
5. Temperature button
6. Adjustment up button
7. Adjustment down button
8. Prog / OK button
9. Main switch
1. High limit reset button
2
Publicidad
