ledscom LC-EL-071-W Instrucciones De Montaje página 5

1. Disconnect the building-side connecting
cable from the power supply and secure it
against being switched on again. To do
this, trip the corresponding circuit breaker
of the house installation.
Loosen the screws (3) and remove the
lamp (1) from the mounting pot (2).
Place the installation pot (2) in its mounting
position.
4. Connect the connection cable if
necessary. with an extension cable or
directly with a transformer that has the
appropriate plug-in system (Figure 2).
Screw the cap tightly to protect the
connection from water. Make sure that the
screw cap is not in the water.
Now place the lamp (1) in the mounting pot
(2) and fix it in place using the supplied
screws (3).
6. Turn the power back on. The installation
is now complete.
Subject to technical changes
LEDs Com GmbH, Dohrweg 2a, D-41066 Mönchengladbach, www.leds-com.de, Tel. +49 (0) 2161 - 5 75 99 76
English Ground recessed light (LC-EL-071-W) - Assembly instructions
Figure 1
1: Luminaire
2: Installation pot
Figure 2
3: Screws (cover)
05/2022