Installation; Cleaning, Care & Maintenance; Daily Maintenance - Gastrodomus BERING05 Manual Del Usuario

IV. INSTALLATION:
1. Remove the appliance from the packaging. Make sure that all protective plastic film and coatings are
thoroughly removed from all surfaces. To prevent injury or damage to the unit, the appliance should be
unpacked and set up by two people.
2. Maintain a distance of 20cm (7 inches) between the unit and walls or other objects for
ventilation. Increase this distance if the obstacle is a heat source.
3. Level the appliance by adjusting the screw feet. It should be placed on the level solid floor or base to
reduce the vibration and noise.
4. The temperature in the place where the showcase is located must be between 10 and
32℃(Climatic Class 4). Avoid locating it in direct sunlight or near heat source such as an oven or
a radiator.
5. Please make sure the appliance is properly ventilated.
6. Power supply and voltage at the operating point used comply with the details on the rating label.
The plug must be accessible after installation
7. Correctly connect and disconnect the plug. Never pull by the supply cord.
8. If the showcase is to be shut down for long period, switch it off and disconnect the plug from socket
outlet. Clean the appliance and leave the lid open to prevent odor.
9. Important! For your personal safety, this appliance must be properly grounded.
This appliance is equipped with a cord having a grounding wire, with a grounding plug. The plug must be
inserted into an outlet that is properly grounded and installed. Consult a qualified electrician or service
center if you do not completely understand the grounding instructions. If doubt exits as to whether the
appliance is properly grounded, have a qualified electrician check the circuit to make sure the outlet is
properly grounded.
10. If the cable does not reach the nearest socket, either rearrange your store layout or ask a qualified
electrician to fix a new socket.
11. If power is cut off, wait for at least 3 minutes before restart the unit to avoid damaging the
compressor.
CLEANING, CARE & MAINTENANCE
V. DAILY MAINTENANCE:
Switch off and disconnect from the power supply before cleaning.
- Clean the enclosure and interior of the appliance as often as possible.
- Wash the unit with moist cloth. Never allow the switch, control panel, cable or plug to get wet.
19