Installationand Use; Safety Instructions; Use - Casselin CFE7B Manual De Instrucciones

5. INSTALLATION AND USE

5.1 Safety instructions

ELECTRICAL HAZARD
Danger due to electric current!
• No contact with heat sources should take place with the electrical cord.
• The cord should not hang over the edge of a table or counter.
• Do not pour water into an appliance that is in operation or still hot.
• The device must be properly connected and comply with the regulations in force.
WARNING
While operating, the device can reach high temperatures. To avoid burns and accidents, do not use the
device if it is malfunctioning, and do not use non-original spare parts.
ELECTRICAL HAZARD
Danger due to electric current!
If incorrectly installed, the device can be dangerous and cause injury. Before any installation, check the data
of the electrical network. Connect the device only when there is compliance. The device must be unpacked
and fully checked before connection by a professional.

5.2 Use

WARNING
The setting up of the device installation and maintenance should only be carried out by professionals.
• Do not leave the appliance running without watching it.
• During use, your hands must be dry.
• Do not move or tilt the device during operation.
MANUAL
The device must be completely removed from its packaging. All guards must be completely removed.
Place the unit upright on a solid, flat surface Never stand the professional fryer on a flammable surface.
Do not install this device near open fires or other heating devices.
Carefully clean the device and its accessories. Do not use abrasive products.
The device must be plugged directly into a wall outlet. Using a power strip will trip the device.
The device must be placed with a safety distance of 10 cm from the wall.
Check that there is no water in the oil pan then pour oil into the pan. Two marks are inscribed in the oil tank.
Minimum and maximum quantities must be respected. It is recommended to use a quality oil, vegetable oils
less saturated with fats are recommended. (When using solid shortening, always melt it before adding it to
the frypot)
Electrical connection: the installation and commissioning of the device must be entrusted to personnel with
the necessary skills for this purpose and carried out in compliance with the accident prevention standards in
force. Be sure to make the connection in accordance with the data given on the technical characteristics
plate. Power outlets should be near the device and easily accessible. If this equipment is wired directly to the
power supply, a means of disconnecting the power supply must be incorporated with contact separation of
at least 3mm for all poles.
Change the oil regularly. After the fryer and the oil have cooled, carefully pour the used oil into the collection
container and dispose of it in accordance with the rules of environmental protection.
Plug in the device once the oil tank has been filled up to the mark.
Once plugged in, the red indicator light comes on.
EN