Publicidad
Idiomas disponibles
Idiomas disponibles
C.
Operation ON / OFF button. The motor
starts in first speed and the anti-condensation
resistor is powered. When pressed, the border
of the - key lights up. When OFF is pressed, the
motor and the anti-condensation resistance
stop and all edges of the keys turn off except for
Key A if the light is on in the ON position.
D.
Speed increase button, set speed
indicator. Each press increases the speed of
the motor, illuminating the edges of the keys as
follows: in second speed, the edge of the C key
lights up; in third speed the edge of Button D
lights up. The fourth speed (intensive) is ONLY
timed and remains active for about 7 minutes
with intermittent illumination of the edge of
Button D, after which the motor automatically
switches to third speed and the lighting of the
edge of Button D returns to fixed.
E.
Timer button. Once pressed, at the first,
second and third speed it switches off the
motor and the anti-condensation heater after
about 15 minutes of operation at the set speed.
Once you press the edge lighting of the set
speed button, it will be intermittent.
CLEANING
The hood must be cleaned frequently externally
and internally with a damp cloth and neutral
non-abrasive detergents. The glass front panel
can be treated with normal products specific
for glass. ATTENTION! The anti-condensation
resistance protected by a steel cover is housed
in the lower rear part of the glass front panel:
carefully clean the part using only a cloth
moistened with water.
To keep the anti-condensation function efficient,
it is advisable to keep the grease filters and the
entire internal part of the hood thoroughly clean.
When removing the grease filters following the
sequence indicated in fig. 2A-2B, be careful
to move them by keeping them in a horizontal
position: this is to prevent excess liquids inside
them from escaping and falling on the hob or on
underlying elements.
en
es
For cleaning DO NOT use alcohol or
products that contain it.
We decline all responsibility for any
damage caused by non-observance of
what is reported.
30
30
Publicidad
