Publicidad
Idiomas disponibles
Idiomas disponibles
RX1
RECEIVER CONNECTION
POWER SUPPLY (2 and 3). The receiver can be powered at 12 or 24 Vac/dc. If you use direct current
respect the polarity. (The positive in the terminal no. 3).
ANTENNA (1 and 2). The antenna should be connected with positive side in the terminal no.1 and the
negative in the terminal no. 2.
If you use only one cable (17 cm for freq. 433.92 Mhz - 8,5 cm for freq. 868 Mhz), this has to be connected
to the terminal no. 1.
OUTPUT. The relay output is a normally open contact (see terminals 4 and 5).
Please don't connect the cable s to high tension and make sure that the current is not more than
1 Ampère
USING OF THE RECEIVER
*** IT IS NECESSARY TO RESET THE MEMORY ***
ATTENTION!! this operation cancel all the codes in the memory.
It is necessary to cancel the memory before learning:
1.
Make sure that the output has not been activated (the contact of the relay is open).
2.
Make sure that the receiver is not learning. The red led must be switched off or it fl ashes shortly
3.
Keep pressed the button till the red led is lighting.
4.
Wait till the red led is switched off or it is fl ashing.
1 Channel receiver with self-learning,
it manages standard codes
from 12 till 64 bit and rolling HCS©
BUTTON
+ ANTENNA
- ANTENNA
+ POWER SUPPLY
RELAY OUTPUT
1
-
2
+
3
4
5
-3-
LED
LED
Publicidad
