Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INFORMATIONS
•
If you remove the ignition key before repairing, you can prevent the engine from being started
accidentally and resulting in engine damage.
•
These instructions are provided as a guide only and does not replace a workshop manual.
Always refer to the vehicle-specific service literature, particularly the technical data such as
torque values and instructions for disassembly/assembly, etc.
•
After repair or before starting the engine, turn a minimum of 2 turns by hand and check the
timing again.
•
Turn the engine only in the normal direction of rotation (clockwise unless otherwise specified)
•
Do not use locking tools for camshaft and crankshaft as a counter-holder, during loosening or
tightening screws on pulleys, camshafts or crankshafts. This can damage tools and engine
components. Only use tools that are suitable for this purpose.
USE
Camshaft setting tool,
to be used as OEM 2456372 / 2358122
for setting and fixing the camshaft in the setting
position.
1
Camshaft setting tool holder
3
Camshaft setting tool (exhaust)
4
Camshaft setting tool (intake)
5
Setting tool supports
10
Fixing screws
The adjustment tools must engage into camshafts
profile.
Timing chain pre-tensioning tool (2),
to be used as OEM 2 455 654.
Used to pretension the timing chain.
Crankshaft setting pin (6),
to be used as OEM 2288380.
For positioning and fixing the crankshaft in the ignition
TDC of the first cylinder.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
