Tabla De Contenido; Introduction; Setup; Converting The Gun To Pressure Feed - Titan CAPSpray HVLP Power Cart Manual Del Propietário

Table of contents
Safety ......................................................................................... 2
Introduction ............................................................................... 3
Setup .......................................................................................... 3
Converting the Gun to Pressure Feed................................. 3
Mounting the Turbine .......................................................... 4
Connecting the Power Cart ................................................. 4
Hose Configurations ............................................................ 4
Preparing to Spray .............................................................. 5
cleanup ..................................................................................... 5
Troubleshooting ....................................................................... 6
Parts List ............................................................................ 20-21
Warranty .................................................................................. 24

Introduction

The HVLP power cart is designed for use with CAPspray spray
systems. The power cart adds tremendous versatility to an
already complete system. Components of the HVLP power
cart include a power switch, a cart, a pressure pot assembly, a
compressor assembly, a pressure pot inlet, a pressure pot hose,
a pressure pot outlet, a fluid hose, and a turbine bracket.
3/8" X 30 ft
Fluid hose
Latch Bracket
Pressure Pot
Air Inlet
Pressure Pot
Fluid Outlet
Pressure Pot
Assembly
© Titan Tool. All rights reserved.
Cart
Turbine
Bracket
Power Switch
Compressor
Assembly
(inside housing)
Pressure Pot Air Hose
3

Setup

Use the following procedures to set up your spray gun and HVLP
power cart.

converting the Gun to Pressure Feed

Before using the HVLP power cart, it is necessary to convert your
spray gun from a cup gun to a pressure fed gun.
1. Loosen the retaining nut using a wrench and remove the
one quart cup assembly.
2. Pull the air tube off of the air tube fitting on the spray gun.
3. Remove the air tube fitting using a 1/4" wrench.
4. Thread the set screw into the air tube fitting location and
tighten into place.
Air Tube Fitting
Optional (in place of steps 3 and 4): If desired, a
temporary cap (also included) can be used to close off
the air tube fitting rather than performing steps 3 and 4
above. This is a convenient method of capping the air
tube fitting if the operator will be frequently switching
back and forth between a 1-quart cup and a pressure pot.
Air Tube Fitting
Air Tube
Retaining Nut
Cup Assembly
Set Screw
Air Tube Cap
English