ledscom LC-L-262 Instrucciones De Montaje página 5

1. Disconnect the building-side connecting
cable from the power supply and secure it
against being switched on again. To do
this, trip the corresponding circuit breaker
of the house installation.
2. Remove the mounting plate (1) by
loosening the screws (2). Then carefully
lay the light on its side so that it cannot be
damaged.
3. Drill two holes in the mounting base and
place there if necessary. Dowel in. The
positioning of the holes should correspond
to those of the screw holes (3) on the
mounting plate. Make sure that the dowels
are flush with the substrate.
4. Poke a hole in the sealing ring (4) with a
knife or wrench. Guide the building-side
connection cable through this and then fix
the mounting plate (1) to the mounting
base with the aid of two screws. Make sure
that the arrow (5) points upwards.
5. Connect the wires of the cable
according to "Figure 2". Place the luster
terminal in the receptacle (6) provided for
this purpose.
6. Place the light back on the mounting
plate (1). The water outlet (7) must point
downwards. Then retighten the screws (2)
to fix the light to the mounting plate.
7. Turn the end piece (8) of the lamp
counterclockwise to insert the bulbs. Then
tighten the end piece hand-tight. The
installation is now complete.
Subject to technical changes
LEDs Com GmbH, Dohrweg 2a, D-41066 Mönchengladbach, www.leds-com.de, Tel. +49 (0) 2161 - 5 75 99 76
English
Figure 1
1: Mounting plate
2: Screws
3: Screw holes
4: Sealing ring
Figure 2
Wall lamp (LC-L-262) - Assembly instructions
5: Arrow
6: Recording
7: Water outlet
8: End piece
11/2022