Wall Mounting - Makita DC18WC Manual De Instrucciones

Wall mounting

WARNING:
Make sure to use two screws for hanging the charger on the wall, and anchor the charger
on the wall with another screw. Otherwise the charger may fall and cause serious injury.
WARNING:
Always be sure that the charger is unplugged and the battery is removed from the charger
before performing wall mounting work.
WARNING:
Follow the steps instructed in this manual, and complete the whole procedures at once.
The charger may fall and cause injury or damage if you stop the work in the half way.
WARNING:
Check tightness of the screws on regular basis. Otherwise the charger may fall because of
loosen screw.
WARNING:
Clean the terminal parts of the charger on regular basis with an air duster etc.
CAUTION:
Carefully choose a stable wall for mounting the charger. Make sure there is no hindrance
to mounting work or charging operation. The gross weight of the charger and battery reach approximately
1.1 kg. Provide sufficient reinforcement for the wall if necessary.
CAUTION:
Be careful not to drop the battery cartridge when inserting or removing the battery from the
wall-mounted charger. Hold the battery cartridge firmly and keep a stable posture.
You can mount the charger on the wall. Make a clearance around the charger as shown in the figure.
► Fig.3
NOTE: Things you need to prepare:
— Two screws - hanging the charger
Screw size : 4 mm x more than 20 mm.
Screw head size : Less than ø9 mm and less than 3.5 mm thickness.
— One screw (4 mm x more than 25 mm) - for anchoring the charger.
— Tools - for tightening screws
1. Fix two screws for hanging on the wall.
2. Hang the charger on the wall using the hook on the back.
► Fig.4
3. Fix the charger by tightening an anchor screw at the top of the charger.
► Fig.5
7 ENGLISH