Installation And Connection; Radio Interference - Beko MOB 20231 BG Manual Del Usuario

3

Installation and connection

3.1 Installation and connection
• Remove all packing material and accessories.
Examine the oven for any damage such as dents
or broken door. Do not install if oven is damaged.
• Remove any protective film found on the micro-
wave oven cabinet surface.
• Do not remove the light brown Mica cover that is
attached to the oven cavity to protect the mag-
netron.
• Select a flat surface that provides sufficient
space for inlet and outlet ducts.
30cm
20cm
20cm
20cm
min85cm
• Minimum installation height is 85 cm.
• Rear surface of the appliance should not be
placed against a wall. Leave a clearance of min.
30 cm above the oven; the minimum distance
between the oven and adjacent walls, if any,
should be 20 cm.
• Do not remove the spacers beneath the oven.
• Obstructing the inlet and outlet openings may
damage the oven.
• The appliance is fitted with a plug and must only
be connected to a properly installed grounded
socket.
• The mains voltage must correspond to the volt-
age specified on the rating plate.
• If the plug is no longer accessible after installa-
tion, an all-pole isolating switch must be present
on the installation side with a contact gap of at
least 3 mm.
• Adapters, multi-way sockets and extension
cords must not be used. Overloading can result
with a risk of fire.
12 / EN
WARNING: Do not place the oven
onto a hob or any other appliance
A
that emits heat. Placing the oven
on or close to a heat resource may
damage the oven and consequently,
the warranty will become void.
The accessible surface may be hot
during operation.
C
Do not trap or bend the power cable.
For built-in use, refer to the in-
C
stallation
tained in kit with the model code
MOK 20232 X.

3.2 Radio interference

C
Operation of the microwave oven
may cause interference on radios,
TVs and similar appliances.
• Place the oven as far away from radios and TVs
as possible. Operation of microwave oven may
cause interference to your radio or TV reception.
2. Plug your oven into a standard household out-
let. Be sure the voltage and the frequency is the
same as the voltage and the frequency on the
rating plate.
• In case of interference, it may be reduced or
eliminated by taking the precautions given
below:
• Clean the door and sealing surface of the oven.
• Set the antenna direction of the radio or TV
again.
• Reposition the oven based on the location of the
receiver.
• Place microwave oven away from the receiver.
Microwave Oven / User Manual
information con-