Makita DCL184 Manual De Instrucciones página 14

Installing or removing the blower
attachment
To attach the blower attachment, align the protrusion of
the blower attachment port with the groove on the vent,
and then push it until clicks.
► Fig.31: 1. Blower attachment
To remove the blower attachment, pull the port down-
ward while pressing its top as illustrated.
► Fig.32
Blowing
Point the tip of blower attachment to the object to blow
off and then turn on the tool.
► Fig.33
MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
Cleaning
From time to time wipe off the outside (cleaner body) of
the cleaner using a cloth dampened in soapy water.
Clean out also the suction opening, dust bag/paper filter
mounting area and the dust stopper.
► Fig.34
Wash the dust bag in soapy water when it is clogged
with dust and the cleaner power becomes weak. Dry it
out thoroughly before use. An insufficiently dried filter
may cause poor suction and shorten the service life of
the motor.
► Fig.35
NOTE: Paper filter is a throw-away type.
When the sponge filter is clogged with dust, remove it
from the cleaner and then wipe it off or wash in water.
Removing and installing the sponge
filter
CAUTION:
After cleaning sponge filter, be
sure to install it on the cleaner. If washed in water,
dry it up before installing. An insufficiently dried
sponge filter may shorten the service life of the motor.
To remove the sponge filter, remove the dust bag or
paper filter and then pinch and take it out.
► Fig.36: 1. Sponge filter
Press in the whole edge of the sponge filter against the
recessed wall inside the dust bag/paper filter mounting
area.
► Fig.37: 1. Recessed wall
Storage
WARNING:
and charger in a car. The temperature inside a car
sitting in the sun may exceed 50 °C (122 °F). It may
cause the battery cartridge deteriorated and result in
liquid ejection, smoke emission or a fire.
► Fig.38
WARNING:
ing it in the storage bag. Blocking the air vent may
result in smoking emission or a fire.
► Fig.39
WARNING:
with on-vehicle inverter. It may cause abnormal
heat and result in a fire.
WARNING:
in a car. If the battery cartridge is exposed to the tem-
perature range out of 10°C (50 °F) - 40°C (104 °F), it
may generate heat and/or fire or explode.
CAUTION:
Always store the hose as illus-
trated to avoid tripping, when the cleaner is not
used. Unfolded hose may catch your foot and cause
personal injury.
► Fig.40: 1. Hook 2. Hose
14 ENGLISH
Never leave the battery cartridge
Never use the charger while stor-
Never charge the battery cartridge
Never charge the battery cartridge