Cartridge Replacement - Kemper 1057 Manual De Instrucciones

Thank you for purchasing one of our products. We recommend you carefully read this instruction manual: it contains important information regarding
safety regulations for use and maintenance of the appliance. It is also recommended to keep this document carefully to consult in case of necessity.
Read carefully these instructions to familiarize yourself with the equipment before you assembling it to his gas recipient.
Keep these instructions to read them again later. Category: DIRECT PRESSURE BUTANE.This device shall only be used
with direct pressure butane cartridges Kemper mod. 577. It can be dangerous to try to use other gas cartridges. Use only
in well-ventilated areas.
1. Check that seals (between the appliance and the gas container) are in place and in good condition before connecting to
the gas container.
2. Do not use the appliance if it has damaged or worn seals.
3. Do not use a device that leakage, deteriorated or malfunctioning.
4. This appliance should be used in sufficiently aerated places in accordance with regulations in force. The volume of air
needed for proper combustion and to prevent formation of dangerous unburned gas mixtures is 2 m³ / h per kW.
5. The appliance can operate in horizontal position or any inclination (360°)
6. The appliance should be operated away from flammable materials and at a distance of 70 cm from furniture, walls and
ceilings.
7. If there is a leak on your appliance (smell of gas), take it outside immediately into a well-ventilated flame free location
where the leak may be detected and stopped. If you wish to check for leaks on your appliance, do it outside. Do not try
to detect leaks using a flame, use soapy water (revelgas cod. 1726). Apply solution of soap and water or gas detector
in the interspaces of the unit. If bubbles appear, it means that there is a leak and it must be repaired before use. If you
detect a leak and you cannot repair it, don't try to fix it another way, but contact the customer service.
8. Caution: accessible parts may become very hot. Keep young children away from the appliance.
9. Do not expose the appliance over 40°C / 104°F and to prolonged sunlight.
10. Smoking is prohibited during assembling operation and all operations of the unit.
11. Do not use to light cigarettes, cigars or pipes.
12. Never leave the appliance near heat sources. The product has a cartridge that must not be exposed to high temperatures
as indicated in point 9.
Open the gas regulator a quarter of a turn (in the «ON» direction) and press the ignition button. If you notice anything
unusual during operation, turn the device off immediately. During long periods of operation, it is normal for the lower part of
the cartridge to cool down.
Close the gas regulator (in the «OFF» direction) after using the device. To regulate the rate, turn right (to decrease) or left
(to increase) the handwheel of the burner. Moreover, the rate can be regulated by turning (with only protecting gloves) the
ring on the burner.
Gas containers shall be changed in a well-ventilated location, preferably outside, away from any sources of ignition, such
as naked flames, pilots, electric fires and away from other people. Check that the cartridge is empty before changing it
(shake to hear the noise made by the liquid).
Make sure that the burner handwheel is turned completely to the «-» position and that the burner is extinguished and cold
before removing the gas cartridge. Check that seals are in place and in good condition before connecting to the gas
container.
Remove the cap from the cartridge, align the notch on the cartridge collar with the position tab of the appliance and, keeping
the cartridge in vertical position, gently press and turn the appliance clockwise until it stops. Slowly turn the handwheel
towards the «+» position to let the gas flow in and then press the power button. If the appliance does not switch on, repeat
the operation. The appliance is now ready for use. To adjust the flow rate, turn the tap's handwheel towards the «-» position
to decrease the flow rate or towards the «+» position to increase the flow rate.
To avoid a dangerous lengthening of flame caused by burning of cartridge's fuel in liquid phase, the appliance must be
used with an inclination not exceeding 15 ° for the first 10 seconds. After 10 seconds of operation, the appliance is
preheated and can be used at any inclination without producing flare-ups
To turn off the appliance, turn the handwheel fully clockwise until it stops. After use, remove the cartridge from the appliance.
The cartridge must not be left in the environment but in a safe place. Do not pierce the cartridge. Do not throw the empty
cartridge into the fire.
1. Do not modify the appliance. It's dangerous to bring modification on device, remove or disassemble its components or
use components which are not approved by the manufacturer, all of this causes the cancellation of warranty and
manufacturer's responsibility.
2. To clean the body of your appliance, use a cotton wad soaked in warm water and soap. Never use abrasive products.
3. To clean the burner, use a soft brush.
When not using the equipment must be stored upright, in suitable places, protecting it from degradation risks, the place
must be well ventilated and kept away from children.
All questions of the departments services must be formulated to: KEMPER – Via Prampolini 1/Q – 43044 Lemignano di
Collecchio (PR) – Italy – Tel. +39 0521 957111 – Fax +39 0521 957195 – www.kempergroup.it – info@kempergroup.it
DT istr 1057_09/2019
TRANSLATION FROM ORIGINAL INSTRUCTIONS
SAFETY WARNINGS

CARTRIDGE REPLACEMENT

MAINTENANCE
MAINTENANCE – REPAIR
IGNITION
STORAGE
5/20
1057