Mounting The Magnifying Glass; Use; Using The Precision Engineer's Led Magnifying Glass - Powerfix Profi 271696 Instrucciones De Utilización Y De Seguridad

Mounting the magnifying glass

Insert the ball joint
and tighten the fastening screw
clockwise (Fig. A).
Push the fixing clamp
set the desired height. Tighten the fastening screw
turning it clockwise.

Use

Using the Precision Engineer's LED
Magnifying Glass
Turn the retaining screws
clockwise direction. Clamp the item to be repaired with
the alligator clips
Move the On / Off switch
switch on the LEDs
Note: The LED bulbs
Point the precision engineer's LED magnifying glass
with the LED lamps
Release the alligator clips
work piece.
Move the On / Off switch
switch off the LEDs
Before Initial Use / Use
into the corresponding recess
5
on to the mounting rod
7
on the alligator clips
19
in the repair device
18
into position "ON" to
9
.
20
are non-replaceable.
20
at the clamped work piece.
20
in order to remove the
18
into position "OFF" to
9
.
20
for the ball joint
6
.
15
5
and
10
by
8
in a
18
1
GB/MT 49