Safety Warnings For The Use Of Angle Grinder Stand - Truper SOP-E45 Manual

General
• The grinding machine mounted on the stand is suitable for
cutting metals.
• Do not use worn or damaged discs.
• NEVER use discs that are larger than the size indicated for
the tool.
• Wear gloves when handling the discs.
Before operating the tool
• Hold the workpiece properly to avoid
CAUTION
body contact with the cut-off wheel, bending of the cut-off
wheel or loss of control of the tool or workpiece.
CAUTION • Before each use, check that the guard is
properly positioned.
• Make sure that the blade is properly installed, make sure
that it has no bumps or damage. If so, replace it
immediately.
• Use the support in such a way that no person is in the
cutting line of the blade.
• Keep the grinder stand on a perfectly level surface, where
there is enough space to properly handle and support the
workpiece.
• Be sure to tighten all screws and clamps before turning on
the grinder.
While operating the tool
WARNING
• Put hands or any part of your body
away from the cutting area and cutting disc. When
operating the tool firmly hold the cutter head by its handle
to prevent accidental injuries and to prevent loosing
control.
DANGER • Accidental contact with a rotating cutting
disc could cause severe personal injury.
CAUTION • Never cut hands-free nor with a loose
work piece. The clamping screw should fasten it.
• Keep your body on a side of the cutting axle away from
sparks or residues thrown by the tool.
CAUTION • Do not try to remove scrap material
while the cutting disc is rotating.
4
ENGLISH
Safety warnings for the use
of angle grinder stand
WARNING • Remember that the guards do not
protect you from the moving disc under the workpiece, so
never reach under the workpiece while the tool is running.
WARNING
• ALWAYS keep the power cord away
from the cutting area. The power cord should NEVER hang
over the workpiece when cutting.
CAUTION • Never remove the debris accumulated
on the disc by hand, use a brush to remove the debris.
CAUTION • Do not attempt to free a jammed disc
without first switching off and disconnecting the tool.
CAUTION
• Do not try to stop the disc with a piece
of wood or with the spindle lock. Allow it to stop freely
after turning off the grinder.
• Hold it by the insulated parts. If you
CAUTION
accidentally cut a power cord, the metal parts will shock
the operator. In this case, switch off and disconnect the
grinder immediately.
• For parts that protrude from the base, support them on
the left side and use auxiliary supports if required.
After operating the tool
• Make sure the disc comes to a complete stop before
replacing it, secure a work piece, change de cutting angle
or turn off the tool.
• Check from time to time all the nuts and screws are duly
tightened.