Publicidad
Assembly
Filter
• Place the fabric filter (A) inside the screen (B).
• In order for the filter to cover the inner surface of the
screen, place the filter frame (C) inside the fabric filter.
• Make sure that the cloth filter is not folded between the
screen and the frame.
• With its components assembled, place the screen into the
dust compartment cover (D).
• Turn the screen counterclockwise until its notches fit into
the slots in the dust compartment lid.
Preparation
Charging the battery
1. Plug the charger plug into a 127 V~ socket.
2. Insert the battery into the charger by sliding it into
the charger as shown in the picture. The red light
should come on, indicating that charging has
started.
• When the battery is fully charged, the green light
will turn on and the red light will turn off.
• Disconnect the charger from the power supply
when charging is complete.
• If the red-light flashes, the battery is defective,
replace it with a new one.
• If the green light flashes, the battery temperature
is below 32 °F or above 113 °F. Wait until the battery temperature is in the correct range before charging.
Considerations for battery use
The battery comes DISCHARGED from the factory. It will need to be charged for approximately 1 hour before use. The normal
charging temperature is 32 °F to 113 °F. Outside this range, charging is automatically suspended until it reaches the correct
temperature. The normal discharge / working temperature is 32 °F to 167 °F. If 167 °F is exceeded, the electronic control shuts
off the power to the tool until the temperature reaches the optimum temperature range again. When the battery is below normal
voltage during work, the tool stops working.
Between each charge, give the charger 15 minutes rest. In a hot environment or after prolonged use, the battery may become
too hot to be recharged. Allow the battery to cool before attempting to recharge.
Battery installation
• Once the battery is charged, insert it into the receptacle
on the back of the vacuum housing.
• Slide the battery into the receptacle until you hear a click
to make sure it is securely in place.
• To remove the battery, press the latch (A) and slide the
battery out.
• To make sure the battery is charged, press the indicator
button (B). The color of the light indicates the charge level.
B
A
C
2
B
A
D
1
ENGLISH
7
Publicidad
