Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
(Original instructions)
♦ The plug must be easily accessible so it can be discon-
nected in an emergency.
INSTRUCTIONS FOR USE
Before use:
♦ Remove the appliance's protective film.
♦ Make sure that all the product's packaging has been
removed.
♦ To eliminate the smell given off by the appliance when
used for the first time, it is recommended to have it on at
full power for 2 hours in a well-ventilated room.
♦ Prepare the appliance according to the function you wish
to use:
INSTALLING THE PRODUCT
♦ Pull the rear cover handle to remove it (FIG1)
♦ Remove the plastic package from the filter.(FIG2)
♦ Install the filter into the machine (FIG3)
♦ Fasten up the rear cover and connect to the power
source (FIG4)
USE:
♦ The appliance can be used directly connected to the
main.
♦ Extend the cable completely before plugging it in.
♦ Attach the appliance to its base / connector making sure
that it is correctly fitted into place.
♦ Connect the appliance to the mains.
♦ Guide the appliance to direct the flow of air in the desired
direction.
♦ Turn the appliance on, by using the on/off button.
♦ Select the appliance function desired.
♦ Select the desired speed.
Timer function:
♦ The appliance's operating time can be controlled.
♦ Press and hold button (6) for 5 seconds to activate
the Timer. The time will be displayed on the screen
and switch between 1h/2h/4h/8h/0(cancel timing), the
required time is set when stop pressing
FAN SPEED MODE
Cycles through fan speeds:
6
AUTO MODE
♦ Auto Mode uses the sensor inside the air purifier to
adjust the fan speed automatically based on air quality.
♦ For example, if the air quality is bad, the fan will auto-
matically be set to highspeed.
SLEEP BUTTON
♦ Tap this button (1), to turn Sleep Mode on/off.
♦ Sleep Mode operates quietly by using the lowest
possible fan speed, all indicators except sleep indicator
will be off.
♦ Tapping any key, the display will resume for 30 seconds,
and then tap sleep button or fan button within 30 sec-
onds to exit sleep mode and enter the auto mode.
♦ After 30 seconds without button operation, the display
will be off.
Lock/UV-C button
♦ The UV-C button is combined with child lock button.
♦ Tap this button to turn the UV-C on/off. When the UV-C
is turned on, the status indicator lights up, otherwise it
turns off.
♦ For the safety use of UV, when the filter cover is opened,
the UV-C LED will shut off automatically and the
appliance stops working as well. Please always use the
appliance with the filter inside.
♦ Press and hold this button for 5 seconds to activate the
child lock function, and the indicator is displayed on the
lower right corner of the screen.
FILTER REPLACEMENT
♦ When the filter life expires (about 3000 hours of life time)
the filter replacement indicator will blink red to remind
you.
Follow "installing the product" instructions
♦ After change the new filter, press and hold for 5 seconds
to reset.
Once you have finished using the appli-
ance:.
♦ Select the minimum position (MIN) using the speed
control.
♦ Turn the appliance off, using the on/off button.
♦ Unplug the appliance from the mains.
♦ Clean the appliance.
Safety thermal protector:
♦ The appliance has a safety device, which protects the
Publicidad
