AnkerMake M5 Guia De Inicio Rapido página 13

SAFETY
• The power cord shall be connected to socket-outlet with earthing connection.
• The power supply should be installed near the equipment and the socket-outlet must be easily
accessible.
• Only use the power cord provided by the manufacturer. Using unauthorized power cords may
cause danger and violate the authorization of the product as well as the guarantee.
• Plug of the power cord is considered as the disconnect device. Once unplugged, the product is
considered to be disconnected from the power source.
• Do not use the device in an environment where the temperature is too high or too low. Never
expose the device to strong sunshine or wet environments.
• The suitable temperature range for the product and its accessories is 15-35
• It is recommended to supply the device in an environment with a temperature that ranges from
15℃ ~25℃ .
• When supplying, place the device in an environment that has a normal room temperature and
good ventilation.
• This equipment is not suitable for use in locations where children
are likely to be present. This equipment is not intended for use by children.
•
Moving parts. Keep body parts away from moving parts.
•
CAUTION Hot parts. Do not touch.
• Do not use the product in any way other than described herein in order to avoid personal injury or
property damage.
• User should comply with the laws and regulations of the corresponding countries and regions
where the equipment is located (used), abide by professional ethics, pay attention to safety
obligations, and strictly prohibit the use of our products or equipment for any illegal purposes. Our
company will not be responsible for any violators' legal liability under any circumstances.
021 EN
NOTICE
Notice (United States Of America)
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
o C.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: (1) Reorient or relocate the receiving
antenna. (2) Increase the separation between the equipment and receiver. (3) Connect the
equipment into an outlet on a circuit different from that to which the receiver is connected. (4)
Consult the dealer or an experienced radio/TV technician for help.
FCC Radio Frequency Exposure Statement
The device has been evaluated to meet general RF exposure requirements. The device can be used
in fixed/mobile exposure condition. The min separation distance is 20cm.
Notice: Shielded cables
All connections to other computing devices must be made using shielded cables to maintain
compliance with FCC regulations.
EN 022