English; Installing The Blade - Brevetti Montolit F2 Manual De Instrucciones

1. ASSEMBLY INSTRUCTIONS
WARNING!
arefully read the safety manual before using the
machine.
Before leaving the factory, every machine is sub-
mitted to a series of tests in which everything is
thoroughly checked.
Brevetti MONTOLIT is constantly working on the
development of its machines; and therefore re-
serves the right to be able to make any modifica-
tions it feels to be appropriate, and therefore no
claims can be made on the basis of the information
and illustrations shown in this manual.
1.1 Applications
The F2 diamond blade cutter is a technologically
advanced product, suitable for cutting ceramic and
stones materials, including especially hard ones. Its
unique operational system using a wet blade is able
to eliminate all of the dust produced during the cut-
ting process.
The machine is suitable for making, with a high
degree of comfort, straight, miter and special cuts;
with the major advantages in terms of the dimen-
sions, weight and handling of the machine of being
considered a portable product.
1.2 Assembly
Remove the machine from its packaging
and check none of the parts have been damaged.
If they have, replace them with original spare parts.
If any components need changing, only use the
manufacturer's original spare parts.
Prepare a stable surface and clear it of any other
materials for use as a surface for supporting the
machine.
1.3 Connection
Check that the nameplate ratings for the voltage
and frequency of the machine are the same as
those of the electricity supply.
The intake of current must include an earth con-
nection and protection against electrical faults (Dif-
ferential).
When using an extension lead, check that the wire

ENGLISH

is no thinner than 2.5 mm
In carriage, roll up the supply cable. Never pull the
wire to move the machine.

1.4 Installing the blade

6 9
Disassemble the blade's protective casing.
Using a 19 mm spanner, unscrew the lock nut from
the blade flange, and position the disk while care-
fully checking the direction of its rotation.
Each tool is clearly marked with an arrow that indi-
cates the direction of rotation.
Now assemble the blade's protective casing.
Position the upper protective cap of the blade,
which protects the user from possibly getting cut
while working.
So, when making cuts, the cap should be adjusted
depending on the thickness of the piece to be cut.
2. INSTRUCTIONS FOR USE
WARNING!
Before beginning any cutting operation, and while
performing the same, make sure that the water
level is high enough to cover the diamond part of
the blade. Filling or refilling can be done straight
into the tank.
Periodically replace the water in the tank. Work-
ing with clean water prolongs the useful life of the
blade and improves its performance.
Place the blade protection about half a centimeter
above the surface of the tile to be cut and lock the
blade protection by fully pressing in the bolt.
2.1 Using the blade
• Do not use scratched or cracked diamond blades.
• Do not stop the blades using lateral pressure.
• At the end of a day's work, empty the machine
of water, as prolonged immersion can deteriorate
the blade.
9
.
2
6 9