Publicidad
Step 33
1
D133
O
Groove
å
Insert the DRAWER SIDES (D133 and D139) at an angle
into the slot at each end of the DRAWER FRONT (O).
3
D133
å
Fasten the DRAWER BACK (D77) to the DRAWER SIDES (D133 and D139). Use four BLACK 1-9/16" FLAT HEAD SCREWS (30S).
å
NOTE: Be sure the DRAWER BOTTOM (D708) inserts into the groove of the DRAWER BACK (D77).
www.sauder.com/service
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D139
D77
D708
D139
2
D133
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide the DRAWER BOTTOM (D708) into the
grooves in the DRAWER SIDES (D133 and D139)
and DRAWER FRONT (O).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
(4 used in this step)
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
426918
9
With the palm of
your hand, tap
the DRAWER
BOTTOM down
U n fi
into the groove.
n i s h
s u r
e d
f a c
e
D708
D139
O
30S
Page 39
Publicidad
