Publicidad
Idiomas disponibles
Idiomas disponibles
Select the desired position by means of the particle size regulator 11.1.
By turning the regulator clockwise, the selector (11.1c) moves and closes the opening,
while it opens if the regulator is turned anti-clockwise.
To use the bowl without selector, firmly grasp the bowl body and use your other hand to
rotate the particle size regulator (11.1) clockwise until it is ejected from the upper part
(11.2).
INSTRUCTIONS FOR USE
Before each use, clean hands thoroughly and clean the device as described in the
section on "CLEANING SANITISATION DISINFECTION". During use, it is advisable to
protect yourself from any dripping. It is recommended that each person use their
own nebulizer cup and accessories to prevent risk of infection due to contamination.
This device is suitable for the administration of medical substances and not, for
which the administration via aerosol is foreseen; these substances are to be in any
case prescribed by the Doctor. In case of too thick substances, the dilution with a suit-
able physiological solution could be needed, according to the medical prescription.
1. Pour the medication prescribed by the physician into the lower part (11.4). Insert
the upper part(11.1+11.2+11.3) of the bowl into the lower part (11.4), then close the
bowl by turning the upper part (11.2) clockwise. Close the nebuliser by turning the
upper part (11.2) clockwise.
2. Connect the accessories as shown in the "Assembly diagram". Sit down in a comfortable
position holding the nebulizer in your hand, place the mouthpiece over your mouth or
use the nasal prong, the face mask, or the Baby mask set.
3. Set the bowl selector to the desired particle size as described under "How to use the RF9
bowl".
-
+
11.1
11.2
11
Publicidad
