5. IOT Reset Button and Indicator
This button can be used to turn on the Bluetooth hotspot for 5 minutes for the user to connect.
6. Error Indicator
This indicator is normally off if no fault is present inside the SHP. It will turn red if there is a fault in
the product. Users can go to the app for a fault diagnostic report. If there is an issue, please contact
customer support for assistance.
7. Power Station Pause/Resume Button
The pause button will physically isolate the 10 load circuits and lock out both connected DELTA Pros.
A signal from the SHP will tell the DELTA Pros to stop outputting power. Please note that this does not
substitute for a service disconnect, nor does it substitute for the de-energization procedure required
before servicing.
Note
This is the only "quick disconnect" that can be used to manually cut all power in an emergency.
AC in and Pro in still energize.
3.3 Hardware Functions
Power Indicators
If the grid power light is on, the SHP is receiving grid power. If the
DELTA Pro light is green but flashing slowly, it indicates that DELTA
Pro is connected but not ready for output. When the light is static
and green, DELTA Pro is ready for power output.
Power Station Enable/Disable Button
When DELTA Pro is connected using the Infinity Port, press the
enable button once to prepare the unit. Press it again to put DELTA
Pro into sleep mode. Holding down the SHP enable button for 3
seconds will start charging the connected DELTA Pro.
Power Station Pause/Resume Button
DELTA Pro is electrically disconnected from the SHP output when this
button is held down. SHP output is cut. To safely disconnect, the user
should still physically disconnect DELTA Pro from the SHP.
EN
5