Mora MRB172N6ASE Guía De Uso Y Cuidado página 15

I
Cleaning and Ca
For hygienic reasons the appliance (including
exterior and interior accessories) should be
cleaned at least every two months.
A CAUTION
The appliance must not be connected to the
wall outlet during cleaning. Danger of
electrical shock! Before cleaning, switch the
appliance off and remove the plug from the
wall outlet socket.
Exterior cleaning
To maintain good appearance of your
appliance, you should clean it regularly.
Spray water onto a cleaning cloth instead
of spraying directly on the surfc】ce of the
appliance. This helps ensure an even distribu­
廿on of moisture to the surface.
Clean the doors, handles and cabinet
surfaces with a mild detergent and then wipe
dry with a soft cloth.
A CAUTION
Dant use sharp objects to clean with, as
they are likely to scratch the surface.
Dant use Thinner, Car detergent, bleach,
ethereal oil, abrasive cleansers or organic
solvent such as Benzene for cleaning. They
may damage the surface of the appliance
and may cause fire.
Interior cleaning
You should clean the appliance interior
regularly. It will be easier to clean when food
stocks are low. Wipe the inside of the fridge
freezer with a weak solution of backing soda
and water, and then rinse with warm water
using a wrung-out sponge or cloth. Wipe
completely dry before replacing the shelves
and baskets. Thoroughly dry all surfaces and
removable parts before pu廿ing them back into
place. Although this appliance automatically
15
e
『
defrosts, a layer of frost may occur on the freezer
compartments interior walls if the freezer door is
opened frequently or kept open too long. If the
frost is too thick, choose a time when the freezer
is nearly empty and proceed as follows:
l. Remove existing food and accessories baskets,
unplug the appliance from the main power and
leave the doors open. Ventilate the room
thoroughly to accelerate the process.
2. When defrosting is completed, clean your
freezer as described above.
A wARNING
Do not use sharp objects to remove frost from the
freezer compartment. Only after the interior is
completely dry should the appliance be
switched back on and plugged back into the
main socket.
Door gasket cleaning
Take care to keep door gasket clean. Sticky food
and drinks can cause gasket to stick to the
cabinet and tear when you open the door. Wash
gasket with a mild detergent and warm water.
Rinse and dry it thoroughly after cleaning.
A CAUTION
Only after the door seals are completely dry
should the appliance be powered on
Replacing the LED light
Warning: The LED light must be replaced by a
competent person. If the LED light is damaged,
follow the steps below:
l. Unplug your appliance.
2. Remove light cover by rising up and pulling out
the LED light.
3. Hold the LED light with one hand and pull it wi佑
the other hand while pressing 佑e connector latch.
4. Replace LED light and snap it correctly in place
and recover the light cover.