Publicidad
1.1 Introduction
1.1.1 Description
®
Automower
Connect brings the menu system to your
mobile device, making it easy to read and change the
product settings remotely. Through this application, you
can receive the current status of the product and send
commands to the product from anywhere in the world.
In case of theft, you get an alarm and can monitor the
position of the product.
1.1.2 Installation
®
The Automower
Connect accessory must be installed
by a dealer. The installation includes a software update
of the product.
1.1.3 Symbols on the product
These symbols can be found on the product. Study them
carefully.
This product complies with the applicable
EU Directives.
This product complies with the applicable
UK Directives.
It is not permitted to dispose the product
as usual domestic waste. Obey national
regulations and use the local recycling
system.
Use direct current only.
1.2 Getting started
You can communicate with your product through
the mobile application Automower
®
Automower
Connect activated, new symbols will show
on the display of the product.
Note:
All countries do not support Automower
Connect because of legal reasons and regional
specified cellular systems. The included Automower
Connect lifetime service only applies if there is a third
part sub-supplier of 2G/4G available in the operational
area. In some countries Bluetooth
to legal reasons.
2 - Operator's manual
1 Operator's manual
1.2.1 Download the Automower
app
Download the Automower
or Google Play to your mobile device.
1.2.2 Create an Automower
account
When you have downloaded the app, you can enter your
e-mail address and a password to make an Automower
Connect account. You will receive a validation e-mail
to your e-mail address. Follow the instructions in the
e-mail in less than 24 hours to validate your account. If
not validated in less than 24 hours, you must make a
account again. You can pair the product and your mobile
device when the account has been made in the app.
1.2.3 Pair with Automower
1.
2.
3.
4.
5.
6.
7.
1.3 Settings
Display and change the settings of the product from
everywhere in the world. For security reasons you
must use short-range communication (Bluetooth
change
Automower
1.3.1 To set the GeoFence center
The GeoFence function makes it possible to monitor the
product, for example in case of theft. Before GeoFence
®
Connect. With
can be used, its center point and sensitivity must be set.
This can only be done from the menu in the product.
1.
®
2.
®
3.
4.
5.
®
is not available due
6.
®
Connect app from App Store
®
Start the app on your mobile device and log in to
your account.
Menu > My mowers .
Select
Push + to add a new product. Follow the
instructions in the app.
Select
Menu > Accessories > Automower
Connect .
Enter the PIN code.
Pairing > New pairing in the menu of the
Select
product.
Enter the 6-digit code shown on the display of the
product.
General and Security settings, or disable the
®
Connect module on the product.
Put the product in the center of the work area.
Accessories > Automower
Select
Enter the PIN code.
GeoFence .
Select
Activate GeoFence and push OK.
Select
New center point to set the source for
Select
GeoFence.
1529 - 003 - 14.10.2022
®
Connect
®
Connect
®
Connect
®
®
) if you
®
Connect .
Publicidad
