Publicidad
Idiomas disponibles
Idiomas disponibles
REFRESH® P HPDC – REFRESH® P TC
We thank you very much for buying a ZERICA producto.
The use of this appliance is simple but read carefully the following notes.
NEVER CONNECT THE SYSTEM TO THE ELECTRICAL NETWORK WITHOUT PREVIOUSLY CONNECTING IT TO THE
WATER NETWORK, OTHERWISE IT WILL BE DAMAGED.
IF WATER HAS BEEN SPILLED ON THE PRODUCT, DISCONNECT IT FROM THE ELECTRICAL MAINS AND
DRY IT CAREFULLY.
INSTALLATION
lt is advisable to dispose the water cooler in a well ventilated place and avoid its exposure to direct sunbeams. Provide a mínimum
clearanoe of 20 cm. on all sides for air circulation.
WATER CONNECTION -
(fig. 1)
On the rear panel you can see the connections: water inlet 1/4" or 3/8"; water waste mm.22 I.D. pipe.
lt is advisable to install a valve into inlet water pipe to prevent any system failure or water leak. Release air from the pipe by holding
faucet button down. Water steady stream flow assures all air removed.
FAUCETS
Glass filler -
(fig. 3)
Do not remove the black lever; screw down "gently" the column spout to the body of the faucet.
Push button bubbler -
(fig. 4)
Stream height is factory set at 2,5 bar. 11 supply pressure varias greatly from this you can modífy the water jet height.
COD. 4.01.10: Remove item "G" and "P" and adjust screw on ítem "V".
COD. 4.01.13: Adjust screw on item "V'.
ELECTRICAL
lnsure a power supply Is ldentlcal In voltage, cycle and phase to that specllled on cooler serial label. REFRESH-P must be connected
wlth ground plate.
TEMPERATURE CONTROL -
The special cooling system of REFRESH P HPDC will chill water in only 5 minutes alter it is connected to main power. Outlet temperatura
can be both lowered and raised moving the screw of the thermostat placed ínside the appliance, behind the front panel.
MAINTENANCE
•
Motors are lifetime lubricated. Cabinet louvers and condensar fins should be periodically cleaned with brush.
•
Excess dirt or poor ventilalion can cause no cold water and serious rlsk to damage the compressor.
ALL OPERATIONS INSIDE THE UNIT MUST BE DONE ONLY BY SKILL TECHNICIANS. BEFORE TO OPERATE
INSIDE THE UNIR UNPLUGS UNIT FROM WATER LINE AND ELECTRICAL SUPPLY.
PAG 3
(fig.2)
ECOLOGICAL GAS
USER MANUAL
ARGANDA AGUAS Y SERVICIOS, S.L. – ZERICA MOD. 27-07-2006
HFC134a
Publicidad
