Use Of Hob - User Instructions; Using The Gas Burner - Haier HAHG7 Manual Del Usuario

Use of hob - user instructions

This appliance must only be used for the
purpose for which it is intended, domestic
cooking, and any other use will be considered
improper and could therefore be dangerous.
The Manufacturer will not be responsible for any
damage or loss resulting from improper use.
Before using burner, be sure, grid perimeters
center the burner as below figure. If you are
using Cast Iron Grids; underneath the grid,
position of it is stated. Be sure for the exact grid
is used in correct position.
• Never use Griddle, Teppanyaki, Fish Kettle, and
similar cookware if the hob has a glass surface.

USING THE GAS BURNER

Prior to switching on the gas hob ensure that
the burner caps are correctly placed within their
position. This hob is fitted with electronic
ignition to ignite the burner.
To ignite the burners carry out the following:
• Push in and turn anticlockwise to the larger
flame symbol
pushed 5 seconds after ignition. The ignition
system will continue to generate sparks as
long as the control knob is being pressed
Warning: If there is no electricity on appliance
to ignite the burner a match or a lighter should
be used carrying out the out the following:
• Place a lighted match or lighter close to the
burner
• To heat one pan, never
u s e t w o d i ff e r e n t
burners at the same
time.
or in position 9 and keep
• Push in and turn the knob anticlockwise to the
larger flame symbol
keep pushed 5 seconds after ignition Warning:
In any case if after 5 seconds the burner has
not lit, stop operating the device and wait at
least 1 min before attempting a further
ignition of the burner.
KNOBS CONTROL
Each knob controls each burner as showed in
the serigraphy. The knobs have 9 steps from
highest flame to lowest flame. Never try to
switch from to 1 0
• To be sure the burner is switched off correctly,
please check the knob position: the index
must be positioned in correspondence of the
"0".
• While you are cooking please always check
the flame to be sure that it is turned on.
• Even if the display screen or knob light is
turned off, the burner could be already turned
on (E.g. electricity shut down).
• While pressing the knob to switch on the
burner, the light of the knob starts sparkling.
• When the burner is switched on, the light of
the knob is turned on.
• If the burner doesn't switch on, the light of the
knob turns off after 3 seconds.
EN 10
or in position 9 and