PLAYKIN AUDI R8 Manual Del Usuario página 49

1. Power off.
2. Remove the battery cover from the remote control, insert two 1.5V AAA batteries (see picture
above) and the remote control light will stay on. Replace the battery cover.
3. Press the "Frequency" button for 2 to 4 seconds, the indicator light on the remote control will
flash.
4. Turn on the main power switch.
5. Pair the code. (Pair the code automatically, no buttons need to be pressed).
6. Once the code is paired, it is not necessary to pair it again.
7. If the batteries are replaced, follow instructions 1 to 4 to pair the code again.
8. Push the left joystick forward, the vehicle will drive forward, push the left joystick backward, the
vehicle will drive backward.
9. Push the right joystick to the left, the vehicle will turn left, push the right joystick to the right,
the vehicle will turn right.
10. Press the "stop" button, the vehicle will stop.
11. Click "Speed Controller", you can control the speed.
LOAD
×
The charging input socket is under the seat.
×
The POWER SWITCH must be in the OFF position during charging.
×
Before the first use, the battery must be charged for 8-12 hours. Do not recharge the
battery for more than 20 hours to avoid overheating the charger.
×
When the vehicle starts to run slowly, recharge the battery.
×
After each use or once a month the minimum recharge time is 8-12 hours, not more than
20 hours.
×
The battery in the battery case can be removed from the car for portable charging.
1. Find the charging input socket under the seat;
2. Plug the charger port into the inlet socket;
3. Plug the charger plug into a power outlet. The battery will begin to charge.
49
EN