Troubleshooting - G-Clean GC80922 Manual Del Operador

PROBLEM
Engine fails to start
Engine hard to start
Engine lacks power
Detergent fails to mix with spray
Pump doesn't produce pressure
Machine doesn't reach high pres-
sure

TROUBLESHOOTING

CAUSE
Engine switch is in OFF position
Fuel valve is CLOSED position
No fuel in tank
Water pressure in hose
Spark plug shorted or fouled
Spark plug is broken (cracked porcelain
or electrodes broken)
Ignition lead wire shorted, broken, or
disconnected from spark plug
Ignition inoperative
Lubricant level is too low
Water in gasoline
Weak spark at spark plug
Recoil starter rope is difficult to pull
Dirty air filter
Detergent injection hose is not properly
submerged
High pressure nozzle attached
Low pressure nozzle installed
Inadequate water supply
Trigger handle or spray wand leaks
Nozzle is clogged
Pump is faulty
Air in line
Hose is leaking
Kink in hose
Diameter of garden hose is too small
Water supply is restricted
Not enough inlet water
Wrong nozzle is attached
Page 14 — English
SOLUTION
Move switch to ON position
Move valve to OPEN position
Fill tank
Squeeze trigger to relieve water pressure
Replace spark plug
Replace spark plug
Replace lead wire or attach to spark plug
Contact authorized service center
Add lubricant to engine
Drain entire system and refill with fresh fuel
Contact authorized service center
Pull trigger to release water pressure
Clean or replace air filter
Insert injection hose into detergent container
or detergent bottle
Use low pressure nozzle (blue) to apply
detergent
Replace with high pressure nozzle
Provide adequate water flow
Check connections and / or replace trigger
handle or spray wand
Clean nozzle
Contact authorized service center
Squeeze trigger on trigger handle to remove
air from line
Replace hose
Eliminate kinks in hose
Replace with 3/4 in. garden hose
Check garden hose for kinks, leaks, and
blockages
Open water source full force
Attach the high pressure nozzle