Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
UP405
4. Now place the keyboard (1) evenly from the above on the housing base. The Keyboard
5. Fasten the keyboard with 2 M6 x 16 (8A) screws along with 2 M6 x 30 (8B) screws.
6. Connect the cables for the Pedal and Subwoofer (11 und 12) to their matching ports on
7. Screw the headphone holder with the supplied phillips screw (13) into the pre-defined
8. Plug the enclosed power cord (7) into the back of the piano and secure it with the supplied
22
must be perfectly aligned with the metal brackets on the sideboards so that they can slide
into their groove. Once this is in place, the angle which the side panel is set in the groves
on the keyboard (1). Then fasten.
both the pedalboard and keyboard. Now attach the Subwoofer cover (6). Move it past
both the following front panels 4 und 5). No screws are needed for the Subwoofer cover.
The cover is held in place by magnets.
hole at the bottom left of the keyboard (1).
cable clips.
Publicidad
