Installation Instructions; Assembly And Cabling (Only For Gw 90 991); Installation - Gewiss RESTART RM 90 Serie Manual Del Usuario

INSTALLATION INSTRUCTIONS

ASSEMBLY AND CABLING (only for GW 90 991)

INSTALLATION

Ensure that the system is powered down before performing any operation.
Connect RESTART to the right hand side of the protection switch by
carefully inserting the triangular pin in the hole on the protection switch
knob in the OFF position (Fig. 1). Invert the two devices to insert the
release pin more easily and push them together until they join.
Install the devices on the rail and
connect the load and line cables.
Before tightening the terminals,
connect the RESTART power
supply wires on the line side and
the control wires on the load side
(Fig. 2).
Fully tighten the terminals,
checking that both connections
are locked.
21
Fig. 1
L I N
E
Fig. 2
E
N
G
L
I
S
H