Transport
Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport it.
Remove the suction pipe with the floor
nozzle from the holder. Hold the appli-
ance at the handle and at the suction
pipe to transport it.
When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
Storage
Caution
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.
Maintenance and care
Danger
First pull out the plug from the mains before
carrying out any tasks on the machine.
Exchanging the flat pleated filter
Open filter door.
Replace the flat pleated filter.
Close the filter door, it must lock into
place.
Cleaning the electrodes
Release and remove the suction head.
Clean the electrodes with a brush.
Insert and lock the suction head.
Troubleshooting
Danger
First pull out the plug from the mains before
carrying out any tasks on the machine.
Suction turbine does not run
Check cables, plugs, fuse, socket and
electrodes.
Turn on the appliance.
All manuals and user guides at all-guides.com
Empty the container.
Suction turbine does not start again
Turn off the appliance and wait for 5 sec-
Clean the electrodes as well as the
Remove blockages in the suction noz-
Exchange the paper filter bag.
Ensure the filter cover properly locks
Clean or replace the membrane filter
Replace the flat pleated filter.
Check for proper installation of the flat
Replace the flat pleated filter.
Clean the electrodes as well as the
Continuously check the filling level in
Suction hose is not connected.
Inform Customer Service
Inform Customer Service
– 4
EN
Suction turbine turns off
after the container has been
emptied
onds, turn it on again after 5 seconds.
space between the electrodes with a
brush.
Suction capacity decreases
zle, suction tube, suction hose, or flat
pleated filter.
into place.
(special accessory) under running water.
Dust comes out while vacuuming
pleated filter.
Automatic shut-off (wet vacuum
cleaning) does not react
space between the electrodes with a
brush.
case of non-conductive liquid.
Automatic filter cleaning is not
working
Automatic filter cleaning cannot be
switched off
Automatic filter cleaning cannot be
switched on
15