Power Switch - GYS WF 35 Manual De Uso

User manual
DESCRIPTION OF THE EQUIPMENT (II)
1- Reel support Ø 200/300 mm
2- Wire-feed motor
3- Cover for coolant outlet (Blue)
4- Cover for coolant inlet (Red)
5- Euro connector (torch)
6- HMI (Human Machine Interface)
HUMAN-MACHINE INTERFACE (HMI)
Please read the Interface User Guide (HMI) which forms part of the complete product literature.
HMI

POWER SWITCH

This equipment has been designed to work exclusively with the KRONOS / NEOMIG-i range of power sources:
KRONOS 400T DUO 075337
KRONOS 400T G 075054
KRONOS 400T GW 075061
NEOMIG-i 400 G 075085
NEOMIG-i 500 G 075092
The connection between these two parts is made through a dedicated interconnection cable, available separately:
Type of torch cooling
Air
Water
ATTACHING THE INTERCONNECTION CABLES
Make sure the main welding power source switched off when connecting or disconnecting the wire feeder. Ensure the machine is
unplugged from the mains, and then wait 2 minutes.
For attaching the interconnection cable between the power source and the wire feeder, refer to pages 3 or 4.
SETTING UP THE REEL
a b
b
a
Translation of the original
instructions
Length Section
5m 70mm²
70mm²
10m
95mm²
1.8m 70mm²
5m 70mm²
70mm²
10m
95mm²
- Remove the nozzle (a) and contact tube (b) from your MIG/MAG torch.
- Open the wire feeder cover.
- Position the reel on its holder.
- Take into consideration the reel stands's drive lug (c). To fit a 200 mm reel, tighten the
plastic reel holder (a) to the maximum.
c
- Adjust the brake wheel (b) to prevent the non-moving spool from tangling the wire when
the welding stops. Do not over tighten as this will cause the power source to overheat.
7- Torch support
8- Interconnection cable connector
9- Gas inlet
10- Power relay connector
11- Interconnection support
12- Transport handles
13- Turret (pivot)
Reference
075443
075450
077553
075467
075474
075481
075504
WF 35
25