Technical Data; Charging Mode - Beta 1838POCKET Manual De Uso E Instrucciones

OPERATION MANUAL AND INSTRUCTIONS ISTRUZIONI PER L'USO

TECHNICAL DATA

SPOT LIGHT
FLOOD LIGHT
BATTERY SPECIFICATIONS
POWER SUPPLY VOLTAGE
CHARGE INPUT
PROTECTION DEGREE
OPERATING TEMPERATURE
USE
Before using the lamp for the first time, select the operating mode as follows:
- Press the ON/OFF switch to enable the lamp.
- Press once to enable the SPOT light.
- Press a second time to enable the FLOOD light in the eco mode.
- Press a third time to switch the lamp to the normal mode.
- Press a fourth time to switch the lamp to the full power mode.
- Pressing a fifth time will cause the lamp to be disabled and switched off.
After the lamp has been on for 5 seconds in the selected mode, pressing the ON/OFF switch will cause it to be SWITCHED OFF.
When the lamp is enabled again by pressing the ON/OFF switch, it will go on in the last selected mode.
The lamp is fitted with a magnetic base for adhering to metal surfaces.

CHARGING MODE

Lamp charge with wireless charging base 1839BRW
- The lamps must be charged when off.
- Place the back of the lamp to charge on one of the two slots of the wireless charging base, 1839BRW, making the magnet
fit the slot.
- While the lamp is charging, its LED charge indicators flash.
- When the lamp is fully charged, the 3 LEDs turn solid green.
- When charge is completed, the lamp can be disconnected from the wireless battery charger.
Lamp charge through USB
- To charge the lamp, lift the USB port cover on the back of the lamp.
- Connect the cable first to the lamp and the power supply, and then to the mains socket, making sure that the mains voltage
is compatible with that of the charger as stated in the TECHNICAL DATA table.
- While the lamp is charging, its LED charge indicators flash.
- The lamp will be fully charged when the 3 LED lights will remain green.
- When the lamp is fully charged, disconnect it from the power supply and close the USB port cover.
Charge level
Turning the lamp on will cause 3 LED charge indicators to light up.
- 3 green LED lights: 100% charge
- 2 green LED lights: 60% charge
- 1 green LED light: 20% charge
- Blinking LED light: flat battery
If the battery is flat, both the light being used and the LED charge indicator will be blinking.
6
LED 6.500K
~250 lm - max 4.5h
LED 10W 6.500K
eco mode ~ 160 lm - max 9h
normal mode ~ 400 lm - max 4h
full power mode ~ 800 lm - max 3h
Li-Ion 3.7 V, 2600mAh
100 - 240V ~ 50/60Hz
DC 5V -1A (USB-C)
IP65 IK07
-10°C ÷ +40°C
EN I