Installationand Use; Safety Instructions; Use - Casselin CPASC30B Manual De Instrucciones

5. INSTALLATION AND USE

5.1 Safety instructions

ELECTRICAL HAZARD
Danger due to electric current!
• No contact with heat sources should take place with the electrical cord.
• The cord should not hang over the edge of a table or counter.
• Do not pour water into an appliance that is in operation or still hot.
• The device must be properly connected and comply with the regulations in force.
WARNING
While operating, the device can reach high temperatures. To avoid burns and accidents, do not use the
device if it is malfunctioning, and do not use non-original spare parts.
ELECTRICAL HAZARD! Danger due to electric current!
If incorrectly installed, the device can be dangerous and cause injury. Before any installation, check the data
of the electrical network. Connect the device only when there is compliance. The device must be unpacked
and fully checked before connection by a professional.

5.2 Use

WARNING
The setting up of the device installation and maintenance should only be carried out by professionals.
• Do not leave the appliance running without watching it.
• During use, your hands must be dry.
• Do not move or tilt the device during operation.
MANUAL
INSTALLATION
The device must be completely removed from its packaging. All guards must be completely removed.
Place the unit upright on a sturdy, flat surface. Never place the device on a flammable surface.
Do not install this device near open fires or other heating devices.
It is forbidden to place flammable objects on the device or within a distance of less than 10 cm from the
device.
Place the appliance under a hood to eliminate steam and bad smells.
Safety distances for flammable materials according to their degree of flammability:
- A non-flammable: granite, sandstone, concrete, bricks, ceramic tiles, plaster
- B flame retardant: acumin, heraclitus, lihnos, itaver
- C1 badly flammable: hardwood, plywood, hardened paper, umakart
- C2 average flammability: chipboard, solodur, cork, rubber, coatings
- C3 easy flammability: wood fiber boards, polystyrene, polyurethane, PVC
The electrical cable must be protected to at least 16 amps. The device must be plugged directly into a wall
outlet. Using a power strip will trip the device.
When the device is placed against a wall, it must be able to withstand a temperature of 60°C.
If this is not the case, it is essential to insert a protective layer.
Ensure that all ventilation openings are not blocked.
EN