Modine GME Serie Manual Tecnico página 27

Heater connection diagram
Important. Application of adequate thermal control systems on feeder lines is mandatory. Performance of all electric
heaters must be periodically controlled to avoid damage due to ice build-up. Modine is not liable in any way for defects
caused by non detected malfunctions. For models supplied with wiring in a junction box, remove the cover to make the
connection. It is compulsory to use power cables with a minimum cross-section according to the technical standards
in force in the country of installation, depending also on the laying method, the length of the cables and their type. To
minimise the risk of indirect contact, it is advisable to earth the unit, using the earth pole (where present). For further
information please refer to the diagrams supplied with the model.
Model with 4mm fin spacing
Connection 230V/1/50-60Hz
Model
Rows
Total power
Model with 7mm fin spacing
Connection 230V/1/50-60Hz
RBA - High power electric heater in coil
RBB - Low power electric heater in coil
RSB - Low power electric heater on inner drip tray
Model
Rows
Total power
Model
(enhanced defrosting)
Rows
Total power
RBA - High power electric heater in coil
GME "ED" 41GH4 41EH4
3 4
W 450 450
GME "ED" 41GL7 41EL7 41FL7
3 4
W 675 675
GME "EDP" 41GL7 41EL7 41FL7
3 4
W 900 900
42GH4 42EH4 43GH4
3 4 3
900 900 1330
42GL7 42EL7 42FL7
5 3 4 5
675 1350 1350 1350
42GL7 42EL7 42FL7
5 3 4 5
900 1800 1800 1800
43EH4 44GH4 44EH4
4 3 4
1330 1750 1750
43EL7 43FL7 44EL7 44FL7
4 5 4 5
1995 1995 2625 2625
43EL7 43FL7 44EL7 44FL7
4 5 4 5
2660 2660 3500 3500
www.modine.com
27