Publicidad
Idiomas disponibles
Idiomas disponibles
FIGURE 18
7. Take 16-Pin wire harness and feed through opening located
near lower left corner of glove box. Figure 19.
NOTE: USE CAUTION WHEN WIRE COULD CONTACT
ANY SHARP EDGES.
FIGURE 19
8. Route 16-Pin PAL harness wire down the side of center
console and tuck under the foam block. Figure 20.
FIGURE 20
Personal Audio Link (PAL)
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCOR-
DANCE WITH GMSPO SPECIFI-
CATIONS.
REVISION
AUTH
9. Continue routing behind plastic electrical panel and leave enough
excess wire to attach module in a later step. Figure 21.
FIGURE 21
STEP 9 - Mount iPod Cable to Glove Box
Procedure
1. Place template on lower left corner outside area of glove box
and drill a hole using a 13/16 drill bit. Figure 22.
FIGURE 22
Line Up Here
2. Insert iPod connector from inside glove box. Figure 23.
FIGURE 23
PART NO.
IR23JN08
INSTALLATION INSTRUCTIONS
DR
TITLE
Personal Audio Link (PAL)
PART NO.
19201501
6200 Grand Pointe Dr., Grand Blanc, MI 48439
19201501
SHEET
5
SHEET
5
21
OF
21
OF
Publicidad
