Before Use; What's In The Box; Precautions For Use - Esoteric N-01 Manual Del Usuario

Before use

What's in the box

Check to be sure the box includes all the supplied accessories shown
below. Please contact the store where you purchased this unit if
any of these accessories are missing or have been damaged during
transportation.
Power cord × 1
Felt pads × 4
Owner's manual (this document) × 1
Warranty card × 1
Note about pinpoint feet
High-precision metal pinpoint feet are attached firmly to the bottom
plate of this unit.
The stands for these feet are loose, but when the unit is placed in
position, it is supported by these pinpoint feet, which will effectively
disperse vibrations.
Chassis
Foot-stand (metal)
o Apply the included felt pads to the bottoms of the foot-stands to
avoid scratching the surface where the unit is placed.
Maintenance
Use a soft dry cloth to wipe the surface of the unit clean.
For stubborn smudges, use a damp cloth that has been thoroughly
wrung out to remove excess moisture.
V
For safety, disconnect the power plug from the
outlet before wiping the unit.
o Never spray liquid directly on this unit.
o Do not use chemically-treated wipes, thinner or similar substances
because they could damage the surface of the unit.
o Avoid allowing rubber or plastic materials to touch the unit for
long periods of time because they could damage the cabinet.
6
Pinpoint foot (metal)
Screws that attach
foot-stand

Precautions for use

o Do not place anything on top of the unit.
o In order to enable good heat dissipation, leave at least 20 cm (8")
between this unit and walls and other equipment when installing
it. If you put it in a rack, take precautions to prevent overheating
by leaving at least 5 cm (2") open above the top of the unit and at
least 10 cm (4") open behind the unit.
Failure to provide these gaps could cause heat to build up inside
and result in fire.
o Place the unit in a stable location.
o Do not move the unit during use.
o Be careful to avoid injury when moving the unit due to its weight.
Have someone help you move it if necessary.
o The voltage supplied to the unit should match the voltage printed
on the rear panel. If you are in any doubt regarding this matter,
consult an electrician.
o Do not open the body of the unit as this might result in damage
to the circuitry or cause electric shock. If a foreign object should
get into the unit, contact your dealer.
o When removing the power plug from the wall outlet, always pull
directly on the plug; never yank on the cord.