Emptying The Appliance; Thermal Cut-Out Reset - NISBETS ESSENTIALS CH732 Manual De Instrucciones

EN
Operation
Power switch
1. Connect the appliance to the power supply.
2. Fill the tank with water to a level between the
'MIN' and 'MAX' marks on the inside of the tank.
Note: Nisbets Essentials recommend that fresh
water should be used each time.
3. Switch the power switch to the On position [I].
4. Turn the thermostat to the desired temperature
to heat-up the appliance. The heat indicator light
will turn on.
5. Once the appliance has heated the water, the
heat indicator light will turn Off.
6. Reduce the heat setting on the Thermostat to
maintain temperature.
WARNING: Do not allow the water
to drop below the 'MIN' level during
operation. Otherwise, severe
damage to the heating element could
result.
4
CH732_ML_A5_v1_20220428.indb 4 CH732_ML_A5_v1_20220428.indb 4
Maintaining Water Levels
Heat Indicator Light
It is important to regularly check the water level in
the Bain Marie tank.
•
•

Emptying the Appliance

Thermostat Dial
Use a suitable container to remove the water from
the appliance.

Thermal Cut-Out Reset

This appliance is fitted with a Thermal Cut-Out
safety feature. Should the temperature exceed safe
levels the appliance will automatically cut power.
The thermal Cut-out switch is located on the rear of
the appliance. To reset the appliance after a sufficient
cool-down period:
1. Unscrew the reset switch cover.
2. Press the small reset switch down until it clicks,
3. The appliance is now reset and can be used as
Always keep the water level above the 'MIN' mark
on the inside of the tank during operation.
Damage to the heating element can occur if
the tank boils dry and the element may have to
be replaced. This is not covered by the Nisbets
Essentials warranty.
Note: Always switch the appliance
off and allow the water to cool before
emptying.
using a blunt pointed instrument.
normal.
2022/4/28 10:25 2022/4/28 10:25