dB Technologies FIFTY Serie Manual De Uso página 33

English
FIFTY SUB INPUT, OUTPUT AND CONTROL SECTION
1. AUDIO INPUT AND LINKING ("Balanced audio")
Input and output compatible with balanced XLR cables.
In particular:
• "Input" is used to connect the audio signal from
the mixer;
• "Output Link" is used to link the signal to other
devices in a daisy-chain configuration.
2. RDNet NETWORK CONECTION INPUT AND
LINKING, RDNet STATUS LEDS
Section compatible with network cables fitted with
etherCON/RJ45 connectors. In particular:
• "Data In" must be connected to devices such as
RDNet Control 2 or Control 8
• "Data Out" is used to link the network to other
devices in a daisy-chain configuration
The LEDs indicate the network (RDNet) operating status
of the monitor.
In particular:
• "Link" illuminates to indicate that the RDNet network is active and has recognised the device
• "Active" flashes to indicate the presence of data traffic
• "Remote Preset Active" signals that all the local controls on the amplifier panel are bypassed by the RDNet
remote control
3. USB SERVICE DATA
Using this standard type B USB port, you can update the product's firmware using a PC and USB BURNER
MANAGER. For further information, refer to the "DOWNLOADS" section of the http://www.dbtechnologies.com
website and the "UPDATING THE FIRMWARE" chapter.
4. STATUS LEDs
The LEDs provide an immediate indication of the subwoofer status, in accordance with the logic summarised in
the table below:
Power up
Use
Partial malfunction
Total malfunction CYCLIC FLASHING
Fifty Line
Limiter
OFF
COMPRESSION SIGNAL OUTPUT
LIMITER STATUS
ACTIVE
2
1
Signal Status
STEADILY LIT FOR A
OFF
FEW SECONDS
STATUS
ACTIVE CYCLIC FLASHING
OFF STEADILY LIT
On
OFF
OFF STEADILY LIT
STEADILY LIT
OFF
Cod. 420120397 REV. 1.0
3
4
5
6
33