Technical Features - Trevi FRS 1480R Manual De Uso

ENGLISH
CONNECTING THE HEADPHONES TO THE TV
Audio cable: Insert a 3.5mm stereo jack audio cable into the Stereo Audio In socket, insert the other end of the
cable into the TV headphone socket. With the audio cable inserted, the optical input is disabled.
Headphone
Note: through the RCA audio output it is possible to connect the TV audio to an external amplification source (for example a
sound bar or amplifier).
Optical cable: If the TV is equipped with a digital optical output, connect this output to the digital optical input on
the base of the headphones. Through the digital optical output it is possible to connect an additional device (soundbar
or amplifier) with an optical input. With the audio cable inserted, the optical input is disabled.
Note: if there is no audio on the headphones, check that the digital audio output is active and set to PCM. Refer to the
instruction manual of the TV.
OPERATION
Note: the headphones and the base are supplied ready to use with a coupling made in the factory; in case of
failure or coupling at the first start-up, proceed with the operation described in point 4.
1. Long press the power key to turn the headphones on or off. When the headphones are turned on, the power
indicator LED will turn blue, wait for the correct pairing of the headphones with the base (about 20 seconds).
2. Adjust the volume by pressing the Volume + and Volume - buttons
3. To mute the headphones, press the MUTE button; to resume listening, press it again.
4. If there is hiss or connection failure, perform a new pairing operation between the base and the headphones.
Turn on the headphones and press the MUTE button on the headphones for about 3 seconds, the power indicator
LED will start flashing. Press the pairing button on the base for 3 seconds, the power led will start flashing. Wait
until the indicator lights stay on steady.
Note: If there is no audio signal, the headset and base will automatically switch to standby after approximately 5 minutes.

TECHNICAL FEATURES

Main power supply: ................. 5V
Headphone batteries: .............3.7V
AC / DC Adapter: ...................Input 100-240V ~, 50 / 60Hz Output 5V
Frequency: .................................2.4Ghz
Transmission power: ...............5 dB
Base dimensions: .....................135 x 103 x 240 mm
Headphone weight: .................200 gr.
1A with supplied 230V ~ 50Hz power supply
400mAh lithium rechargeable
PAG.8
1A - 5W.
FRS 1480R