VONROC VC509AC Traducción Del Manual Original página 14

EN
2. Press the detergent tank (16) onto the stainless
steel container (3) and secure it.
Install the filters (see next paragraph) before
proceeding to attach the detergent tube (29) to the
top section (2).
Filters (Fig. D-2, D-3, D-4, D-5)
Ensure to mount the correct filter,
depending on the intended application of
the machine.
For dry vacuum cleaning:
1. Place the HEPA filter (4) in the filter cage (22).
2. Fit the filter cage (22) and water separator (23)
onto the top section (2) of the vacuum cleaner.
3. Insert the shut-off float (24) and turn clockwise
to lock it in place (fig. D-2).
4. Optional/recommended: Place a dust bag (7) in
the container (3) (fig. D-3).
5. Install the top section (2) on the container (3)
and secure using the clamps (17) (fig. D-4, D-5).
6. Connect the detergent tube (29) to the inlet (30)
on the top section (2) (fig. C-2).
For wet vacuum cleaning:
1. Slide the foam filter (6) onto the filter cage (22).
2. Fit the filter cage (22) and water separator (23)
onto the top section (2) of the vacuum cleaner.
3. Insert the shut-off float (24) and turn clockwise
to lock it in place (fig. D-2).
4. Install the top section (2) on the container (3)
and secure using the clamps (17) (fig. D-4, D-5).
5. Connect the detergent tube (29) to the inlet (30)
on the top section (2) (fig. C-2).
Flexible hose (Fig. E-1, E-2)
1. Insert the end of the flexible hose (14) into the
container (3) and turn clockwise to secure.
2. Connect the detergent tube (20) to the outlet
(31) on the top section (2).
Nozzle/brush (Fig. E-1, E-2)
Select a brush or nozzle depending on the intended
application of the machine.
For cleaning carpets:
1. Connect the suction tubes (12) to the handle
(13).
2. Mount the carpet cleaning nozzle (8) on the end
of the tube (12).
14
For cleaning furniture:
1. Remove the suction tube (12) from the handle
(13).
2. Mount the furniture cleaning nozzle (9) on the
handle (13).
For vacuuming floors:
1. Connect the suction tubes (12) to the handle
(13).
2. Mount the wet & dry floor brush (10) on the end
of the tube (12).
For vacuuming small crevices:
1. Remove the suction tube (12) from the handle
(13).
2. Mount the crevice nozzle (11) on the handle (13).
4. OPERATION
Do not operate the vacuum cleaner without
a filter installed.
Keep the machine fully upright at all times,
especially when vacuuming liquids. If the
machine is tilted or turned over liquids may
enter into the motor and cause irreparable
damage.
Switching on/off and selecting operating mode
(Fig. F)
The on/off switch (1) has three settings:
I On, vacuum cleaning only
O Off
Vacuum cleaning on and detergent spray
enabled
Carpet and furniture cleaning (Fig. G)
Vacuuming will remove larger particles,
which can't be cleaned effectively with the
cleaning nozzles. It is highly recommended
to first vacuum the carpet or furniture
before cleaning. Use the crevice nozzle (11)
to remove particles from furniture crevices.
Preparation:
1. Remove the dust bag (7) from the container (3).
2. Install the foam filter (6) (refer to the previous
paragraph "Filters").
WWW.VONROC.COM