Audizio FOGGIA Manual De Instrucciones página 7

o Set Date format
o Auto Update
Backlight
o Timeout
o On level
o Dimmer level
Languages
Factory Reset
SW version
Before transmission between your BT device and the radio is possible, both devices must be coupled. This process is called
"pairing". The radio is served as a receiver, to receive the music stream to be played on the radio.
If you have already coupled to a BT device before, this connection will be restored automatically when both devices are in
range and BT operation has been selected on the radio. "Pairing" does not have to be repeated. This function may need to be
activated in your BT device, however.
• Press [Mode] until "BT" shows on the display.
• Turn on BT streaming on your device. The device will scan for pairable BT devices in the reception range.
• Select "Audizio Foggia" from the list with found devices.
• Start playback on your BT device. Playback now takes place emitting sound from the radio.
You can listen to the music stored in other audio device or smart phone via the radio, through the connection to the 3.5 mm
aux-in jack on the rear side. Use a cable with 3.5 mm pins at both ends, one end connected to the aux-in jack on the radio, the
other end connected to the earphone jack on the audio device (or line out socket if available).
Press [Mode] until "Auxiliary Input" shows on the display. Play music on the connected device, the sound will be emitted
from the radio.
Alarms will only sound when the unit is "ON" (mains or battery power) or in "STANDBY" (mains power only).
Alarms can be switched on or off in standby mode, however, the alarm parameters can only be set when the unit is turned on.
To set alarms:
Turn the unit on.
To set or change alarm 1, press [Alarm] once, then press [Tune/Select]. To set or change alarm 2, press [Alarm] twice, then
press [Tune/Select]. To exit the alarm setting mode, press [Alarm] again.
The alarm setup prompts you for the following parameters. Select a value for each parameter by turning the [Tune/Select]
knob and press [Tune/Select] to confirm and prompt the next parameter.
• On time - hours and minutes
• Duration - 15, 30, 45, 60, 90 minutes
In case the alarm is not cancelled, the unit returns to standby mode automatically after this time period.
• Source - Buzzer, DAB or FM
If DAB or FM is chosen as the audio source, you will also be prompted to select the last played station or one of the preset
stations (if set).
• Daily, Once, Weekends, Weekdays
Choose the days on which the alarm is active.
Note: if you choose 'Once', you are prompted to enter the date.
• Alarm - Off, On
7