afx light MAGMA-1800 Manual De Instrucciones página 5

After 15seconds the machine will stop automatically)
CONNECTION OF A SIGNAL CABLE
The connection between the output of the first unit and the input of the next unit must be carried
out by a 3-pin XLR cable. Connect the signal cable from the DMX output of the controller to the
DMX IN socket of the first unit, then connect the DMX OUT socket of the first to the DMX IN socket
of the second unit, etc. until you have connected all units. Insert the last connector to the input of
the last machine. (Note: the core diameter of every cable should be 0.5mm at least, double core
screened cable should be used).
Note: Make sure that the internal wires of the 3 pins XLR cable don't touch each other nor the connector.
A DMX signal terminator is recommended on the output of the last unit of the chain. A DMX termi-
nator is a XLR connector with a 120Ω resistor between pin 2 and pin 3 of the XLR connector
MENU DISPLAY INSTRUCTION:
1. Main menu: When the machine is warming up, "Warming Up" is displayed on the LCD. When it
is ready to fog, "Ready To Fog" will be displayed on the LCD
2. Fogging time set up: Interval Set (5-200s)
3. Continuous fogging time set up: Duration Set (5-200s)
4. DMX set up: DMX address (1-512)
5. "No fluid" protection switch: When "Fluid Sensor ON" is displayed, the fluid protection function is
active. If the machin has detected that there is no fluid in the tank, it will display "No Fluid", and
it will stop working. Power off the machine, fill the tank and switch it on again.
6. Light effect selection: When "Inner Flame 0" is displayed, the inner LED light effects are on and
you can set up 9 kinds of effects.
When "Outer Flame 0" is displayed, the outer LED light effects are activated and you can set up
9 kinds of effects
Value
0
1
2
3
4
5
6
7
8
9
REMOTE CONTROL
Button 1: Press start to fog, loose stop to fog
Button 2: Choose inner LED effect: Press once to change one color from Off, to
change to Red, Green, Blue, Amber, Blue+Green, Red+Blue, Red+Green+Blue,
7color changing, and then 7color gradual change
Button 3: Choose outer LED effect: Press once to change one color from Off, to
change to Red, Green, Blue, Amber, Blue+Green, Red+Blue, Red+Green+Blue,
7color changing, and then 7color gradual change
Button 4: LED color switch: Turn on or turn off the LED color
INSTALLING THE BATTERY IN THE REMOTE CONTROL
• Place the wireless remote face down on a flat surface.
• Push the compartment cover into the direction of the arrow to slide the battery compartment
Effects
No effect
Red LED
Green LED
Blue LED
Amber LED
Green+Blue LED
Red+Blue LED
Red+Green+Blue LED
7colors effects
7colors gradual change
WWW.AFX-LIGHT.COM
5 EN