Rear Panel; Multimedia Remote Control - Sanyo DS31590 Manual Del Propietário

REAR PANEL

UHF/VHF/CATV
75
AUDIO VIDEO INPUT
Cable / Antenna Input
Terminal (75 ohms)

MULTIMEDIA REMOTE CONTROL

Operates your TV, VCR, Cable Converter Box, and Satellite Receiver. Simply program it
according to the directions on pages 7~9. Then press the proper function key (VCR, TV,
CABLE, SAT/AUX) to set the remote control to operate each product. The SAT/AUX mode
can be programmed to operate a Satellite Receiver, VCR, or Cable Box. Also, this remote
offers large Channel, Volume, and Power keys that glow-in-the-dark.
INSTALLING BATTERIES (2 AA not included)
1. Remove the battery cover by pressing the tab and tilting
the cover upward. Insert batteries. Make sure you match
+
/ signs on the batteries with marks inside the
remote control.
2. Replace battery cover. The remote control is ready!
Notes:
– Do not mix old batteries with new ones or mix
different types of batteries together.
– Remove batteries from the remote control if it will not
be used for a month or more. Weak batteries may leak,
causing damage to the remote control.
IMPORTANT NOTE: Spent or discharged batteries must
be recycled or disposed of properly in compliance with
all applicable laws. For detailed information, contact
your local County Solid Waste Authority.
S-VIDEO
AUDIO
OUTPUT
L
AUDIO VIDEO
R L
(MON0)
R
Audio/Video Input Jacks (AV1)
Connect external video equipment
here (see page 12).
S-Video (Super-Video) AV1 Terminal
To enhance video detail use the S-Video
jack instead of the Video jack, if available
on your external video equipment.
(S-Video AV1 connection will override
a Video connection.)
Audio Output Jacks (Fixed/Variable)
Connect external audio
equipment here (see page 11).
QuickTips
Make sure all cable
connectors are fully
seated on jacks.
See pages 11~12
before connecting
external audio/video
equipment.
Cables are not
supplied for connect-
ing your external
equipment.
A solid Blue screen
with the word Video
displayed means that
the Video mode is
selected, but no signal
is being detected at
the Video jack. Check
connection, and
turn on external
equipment.
Be sure batteries are
installed correctly.
Point the remote
control toward the
equipment you want
to operate. Objects
between the remote
control and the
equipment may cause
misoperation of the
remote control
function.
Need help?
Visit our website at
www.sanyoctv.co
m
or
Call 1-800-877-5032
5