LG CBGS3028 Serie Manual De Instalación página 11

en-us_main.book.book Page 11 Friday, November 4, 2022 8:08 AM
GFCIs are devices that sense leakage of current in
a circuit and automatically switch off power when
a threshold leakage level is detected.
These devices must be manually reset by the
customer.
The National Electrical Code requires the use of
GFCIs in kitchen receptacles installed to serve
countertop surfaces.
Performance of the cooktop will not be affected if
it is operated from a circuit protected by a GFCI,
but resetting the circuit can become a nuisance.
CAUTION
• If needed, have the circuit checked by a qualified
technician to make sure the receptacle is
correctly grounded.
DO NOT use an adapter plug because
disconnection of the power cord places undue
strain on the adapter and causes eventual failure
of the adapter ground terminal.
If only a two-prong wall receptacle is available, it
must be replaced with a three-prong (grounding)
receptacle by a qualified electrician before
plugging in the cooktop.
The installation of appliances designed for
manufactured (mobile) home installation must
conform with the Manufactured Home
Construction and Safety Standard, Title 24 CFR,
Part 3280 [formerly the Federal Standard for
Mobile Home Construction and Safety, Title 24,
HUD (Part 280)] or with local codes where
applicable.
The installation of appliances designed for
recreational park trailers must conform with state
or other code or, in the absence of such codes,
with the Standard for Recreational Park Trailers,
ANSI A119.5
4. Sealing the Openings
Seal any openings in the wall behind the cooktop
and in the floor of the cabinet when hookups are
completed.
5. Assembling the Surface Burners
CAUTION
• DO NOT operate the burners without all parts in
place.
Place the burner caps and heads on the cooktop.
Make sure that the caps and heads are placed in
the correct locations.
Medium Burner Head and Cap
a
Extra Large Burner (Center) Head and Cap
b
Small Burner Head and Cap
c
Large Burner Head and Cap
d
Make sure the hole in the burner head is
a
positioned over the electrode
6. Assembling the Grates
The install location and orientation are imprinted
on the bottom of each grate. Follow the imprints to
correctly assemble the grates.
Left FRONT
a
Center FRONT
b
Right FRONT
c
7. Checking Ignition of Surface
Burners
Operation of all cooktop burners should be
checked after the cooktop and gas supply lines
have been carefully checked for leaks.
INSTALLATION 11
.
b