Clatronic EWB 3785 Manual De Instrucciones página 11

Control Lamp ICE FULL (Ice Cube Container Full)
The temperature sensor stops the ice cube production as
soon as the ice cube container is full.
The ICE FULL control lamp flashes. The appliance switches
into standby mode.
• Remove the ice cubes with the supplied ice cube scoop.
When removing the ice cube container, some water will
drip through the holes onto the floor.
• The control lamp ICE FULL turns off and a few moments
later ice cube production starts again.
WARNING:
• Switch off the appliance before cleaning and disconnect the
mains plug.
• Never immerse the appliance in water to clean it. Doing so may
lead to electric shock or fire.
CAUTION:
• Do not use wire brushes or other abrasive implements.
• Do not use harsh or abrasive cleaning agents.
• Do not use chemicals, acids, petrol or oil products.
• For hygienic reasons exchange the water in the tank
after 24 hours.
• Remove the ice cube container after use. If the water
tank remains open no mould or bacteria can form.
Self-Cleaning
1. Fill the water tank with water up to the MAX mark.
2. Press and hold the button for approx. 5 seconds in
standby mode. The appliance switches to self-cleaning
mode and the CLEAN control lamp lights up.
3. After 15 minutes, the appliance switches back to standby
mode and the POWER control lamp flashes.
Ice Cube Container
Remove the ice cube container. Clean it in warm rinse water
with a little hand dishwashing liquid. Rinse with clean water.
EWB3785_IM
Cleaning and Maintenance
Control Lamp ADD WATER (Water Refill)
The control lamp displays when there is too little water
in the water tank. Ice cube production is automatically
interrupted.
1. Open the lid.
2. Empty the ice cube container.
3. Refill with potable water as described in chapter "Make
ice cubes". Since there may still be water in the appli-
ance, check the MAX mark in the water tank.
4. Now put the ice cube container back in and close the lid.
5. Press the button to resume ice cube production. The
control lamp ADD WATER turns off.
Housing and Interior
• Clean housing and interior with a damp cloth.
• Use a diluted solution of vinegar and water.
Drain Residual Water
Drain the residual water if the appliance is not in use for a
longer period of time. Rest the appliance on a table edge.
Take a bowl and hold it under the drainage opening for the
residual water.
• Pull out the cap at the bottom.
• After the remaining water has drained off, put the cap
back into the opening.
Storage
• We recommend that you keep the appliance in the
original packaging if you do not intend using it for long
periods.
• Always keep the appliance out of the reach of children in
a dry, well-ventilated place.
11
19.07.22